Stone flooring is an indispensable main material for modern decoration, especially natural stone is favored by consumers for its natural and beautiful characteristics. But almost all natural stone no matter how carefully used, after a period of time there will be different degrees of scratches, and slowly lose their luster, greatly affecting the original beauty of the stone surface. Replacement or refurbishment is costly, and if the ground damage is not particularly severe, it is not advisable to do so.

Wax is still widely used today as the first stone care technology. This technology relies on water-capacitated and elastic low-molecular plastic materials to form a covering layer on the surface of the stone to protect the substrate. However, the hardness is at the bottom, easy to change color, and it is necessary to polish and repair the wax frequently, which consumes huge resources, and the black waxing pad containing alloy sand is used in each waxing process, which seriously damages the surface of the stone, and the waxing water with high solvent and strong alkaline penetrates into the stone to form cracks. With the development of new technologies, the use of ** generation technology will be reduced.

Crystallization procedures for marble, granite, etc

Material: stone high-gloss mirror reconstituted powder

Function: It is applied to the crystal hard treatment of marble mirror, protecting the surface of the stone from general scratches, maintaining a bright mirror, waterproof, anti-corrosion, and easier to care for than waxing.

This product is used for wet operation to recreate the high-gloss crystal surface of the stone in a short time, and is used to treat the stone surface that has lost its luster due to wear and tear.

Characteristic:

1) There will be no scratches on the stone surface caused by steel wool

2) It will not discolor the stone surface or leave yellow rust

3) The stone surface is as bright as water, and it is very layered

4) Low cost, time-saving, labor-saving

5) It has the effect of preventing stains from penetrating deep into the inner layer of stone, enhancing anti-wear and anti-scratching

Operate:

1) Use a floor scrubber to thoroughly clean the surface of the marble first

2) Mix the crystallization powder into a paste with purified water and apply it to the grinding pad.

3) Use a 175 rpm mopping machine with a load of 45KG to start grinding, and keep the ground moist during operation.

4) When the surface of the marble forms a high-gloss crystal surface, use a suction machine to suck off the residual paste on the ground.

5) Blot dry with water.

6) Polishing with a polishing pad to make the ground completely dry and bright as a mirror. Comparison of crystallization and waxing

1. Steps:

1. Waxing (1) washing and drying (2) bottom wax drying (2 times) (3) surface wax blow drying (2 times) (4) polishing with high-speed polishing machine;

2. Crystallization (1) scrubbing and drying (2) can be used with a single wipe machine.

2. Texture:

1. The waxing is soft;

2. Crystals are hard

3. Brightness:

1. Waxing in general;

2. The crystalline light is as bright as a mirror

Fourth, hydrophilicity

Waxing absorbs moisture, is easy to soften and roll, strong water resistance, and does not soften and does not roll

Fifth, the number of operators

1. Waxing 3-4 people;

2. Crystallization 1-2 people.